Guides
Practical guides
Glasses rarely break all of a sudden. Usually one temple starts to swing loosely first, then the glasses slide down to the tip of your nose, and a nose pad leaves a reddish mark on the bridge. Many people put up with this for months, although in simple cases everything can be put right at home in one calm evening. Below you will find how to tighten a loose screw in the hinge, straighten the temples and carefully bend the metal nose pad arms. There is also a clear note on where home repairs end: some breakages are best taken straight to an optician's workshop, so that a minor fault does not turn into serious damage to the frame.
A good home repair of glasses looks dull: a well-lit table, a towel, a small screwdriver and no hurry. Anything that needs force is no longer a home repair.
What to have ready
- A small screwdriver with a flat or cross-head tip that fits snugly into the head of the screw.
- A light-coloured towel or a sheet of paper on the table, so a dropped screw is visible at once.
- A good lamp: hinge screws are tiny, and in dim light it is easy to damage the screw head.
- A clean microfibre cloth, so you can hold the glasses by the lenses without leaving fingerprints.
- A mirror in front of which you can try the glasses on after each adjustment.
- The care instructions for your glasses, if you still have them: they sometimes include notes for your particular frame.
Wash the glasses and inspect the frame
Begin with an ordinary clean: under water and mild cleanser you see more than through a greasy film. Then look at the glasses in good light. Find out which temple is loose, whether the nose pads are crooked and whether there are cracks by the hinges or on the bridge. If there is a crack, stop here and take the glasses to a workshop.
A made-up example: after washing you can see that the left temple drops freely when you open the glasses and tilt them, and the right nose pad arm is bent out further than the left one.
Lay the glasses on the towel
Open the temples and lay the glasses on the light-coloured towel with the lenses up. Work over the towel, not over the sink or a carpet: a dropped screw is almost impossible to find, and you may not have a spare at home.
A made-up example: the glasses lie on a light towel under a desk lamp, the screwdriver beside them, and any tiny part on the fabric is visible at first glance.
Tighten the hinge screw
Hold the temple with your fingers near the hinge, push the screwdriver fully into the screw head and turn clockwise in small movements. Stop as soon as you feel resistance. An overtightened screw makes the temple stiff and can even strip the thread.
A made-up example: the screw turns freely, then more firmly, and you stop while the temple still closes smoothly but no longer drops on its own.
Check how the temples move
Open and close each temple several times. The movement should be smooth and the same on the left and the right. If one closes noticeably more stiffly, loosen its screw the tiniest bit. If the screw will not hold and works loose again, the thread is probably worn, and that is a job for a workshop.
A made-up example: after the adjustment the left temple closes slightly more stiffly than the right, you ease the screw back a little, and the movement evens out.
Level the glasses on the table
Open the temples and stand the glasses on a flat table with the lenses facing you. The ends of both temples should touch the table at the same time. If one hangs in the air, the glasses will sit crooked on your face. A metal temple can be bent very carefully with your fingers right at the curve behind the ear; a plastic one is better left alone.
A made-up example: the glasses rock on the table because the right temple is raised. You lower it slightly at the ear curve, and the frame stands level.
Adjust the nose pads
If the nose pads sit on metal arms, you can bend them with your fingers. Bring them closer together if the glasses slide down, and spread them a little wider if they press on the bridge of your nose. Move the arm only the tiniest bit, holding the glasses by the bridge rather than a lens, and try them on in front of the mirror after every adjustment.
A made-up example: the glasses slip to the tip of your nose, you bring the nose pad arms together barely noticeably, try them on, repeat once more, and the glasses stay in place.
Try them on and check the fit
Put the glasses on and look in the mirror. The frame should sit level, the temples should touch your head behind the ears without pressing, and the nose pads should rest evenly on the bridge of your nose. Tilt your head forward: if the glasses do not slip, you have done it.
A made-up example: in the mirror the frame is level, the glasses stay put when you lean over the table, and by evening there are no red marks on the bridge of your nose.
Wash the glasses again and put the tools away
After a repair the lenses are covered in fingerprints. Rinse the glasses, wipe them with microfibre and put the screwdriver back in its usual place so you do not have to hunt for it next time. Remember which screw was loose and check it again in a few weeks.
A made-up example: the screwdriver goes back into its little box on the hallway shelf, and a reminder appears in your calendar to look at the left hinge next month.
Common slip-ups
- Using a knife or a fingernail instead of a screwdriver: the screw head gets damaged and the screw is then impossible to undo.
- Tightening the screw as hard as you can: the temple becomes stiff and the thread wears out faster.
- Bending a plastic frame or temple in the hope of straightening it: plastic can crack without warning.
- Holding the glasses by the lenses during a repair: fingerprints are the lesser problem; it is worse if a lens pops out of the frame.
- Bending the nose pads a long way in one go instead of in small steps with a try-on after each.
- Working over a sink, a carpet or your lap: a lost screw often means a trip to the workshop.
Fallback options
- If you do not have a small screwdriver, it is better to postpone the repair than to improvise with something from the kitchen drawer: the wrong tip damages the screw head.
- If a screw has been lost, do not fix the temple with wire or thread; take the glasses to an optician's workshop, where a suitable screw will be found.
- If your nose pads are moulded into the frame, without metal arms, there is nothing to bend, and only a workshop can adjust the fit.
- If there is no good light at home, the adjustment can wait until morning and be done by a window.
Check yourself at the end
- The temples open and close smoothly and evenly.
- Opened out, the glasses stand level on the table and do not rock.
- The nose pads do not press on the bridge of your nose and do not let the glasses slide down.
- No screws have gone missing, and the screwdriver is back in its place.
- After the repair the lenses have been washed and wiped with microfibre.
- If something did not work out, the glasses have been set aside for a workshop rather than patched up with whatever was at hand.
Catalogue of articles for English-speaking readers
Short standalone notes on looking after glasses will appear in this catalogue, each written for English-speaking readers and devoted to one everyday situation, quick enough to read before the kettle boils.
- ROB RUN Rent a Pro: What to Confirm Before Booking
Five points to get in writing before booking an experienced ROB RUN player, how to tell vague promises from checkable terms, and what only you can verify.
- Fortnite: Save the World — Player Decision Guide
Fortnite Save the World compared: what the PvE mode involves, what you need first, ways to progress, where paid services fit, and realistic alternatives.
- Aion 2 weekly priorities: What New Players Should Know
How a new Aion 2 player can sort the week: what to check first, two sample schedules, how to read outside guides, and what may change with patches.
- A closer look at Aion 2 stronghold battles: Consumer Decision-Making
Aion 2 stronghold battles seen as a player decision: time, readiness and coordination costs, three scenarios, options compared, and reading review pages.
- GTA 6 Release Date Updates and Official Sources: Player FAQ
A dated GTA 6 release FAQ: the official record from Rockstar and Take-Two, a routine for testing new claims, and which pages count as primary.
- Escape from Tarkov: Wipes, Quests and Progression Bottlenecks — Planning for Long-Term Play #1
A practical plan for playing Escape from Tarkov across several resets: what a wipe takes, how to pace skill and quest chains, and a reusable checklist.
What we are working on
- A dish by the front door for your glasses, so you are not hunting for them on a busy morning.
- Glasses on a rainy commute: drying the lenses without smearing them.
- Microfibre cloths: how to wash them and when it is time for a new one.
- Glasses and woolly hats: how not to bend the temples in winter.
- A spare pair in the car: where to keep it so it does not overheat.
Editorial rules
- Articles in this catalogue are written separately for each language version and are not translations.
- Some articles link to third-party websites, including gaming services; we do not control their content, prices or terms.
- We do not sell glasses or care products; we do not publish advertising, rankings, prices or reviews.
Read next
- Sections
Topic map: cleaning lenses, cases and storage, frames and small repairs at home, sunglasses on holiday and in town.
- Questions
Short answers about smears and scratches on lenses, cases for trips, loose little screws and bent temples.
- Reference
The guide's glossary: parts of the frame, care words and sunglasses terms, from the hinge to polarisation.
- Collections
Reading routes: glasses on the beach, several pairs in one bag and glasses in the cold season.
Sources
- The care instructions for your glasses
- Editorial materials of the guide
The advice in this guide is meant for ordinary everyday glasses and for sunglasses worn in town, on holiday and on the road. Frames and lens coatings vary a great deal, so if your glasses came with care instructions, those instructions come before any general rule, and for a serious breakage it is safer to go to an optician's workshop.